- Portable battery charger with charging adapters for all major electronic devices
- Compact car jump starter that can jump start your car 20 times on a full charge
- Ultra-bright LED flash light, strobe light, and SOS signal light that lasts 120 hours
- Built-in protection features: over current protection; short circuit protection; overload protection; over-voltage protection; over-charge protection
- Portable compact design that will easily fit in your pocket, backpack, or glove box for convenience
Tips:
1 When jump-starting a car with a dead battery, you always have to leave PowerAll connected for 10 seconds (or longer) to establish the adequacy of the charge in the battery of your car, wait 10 seconds during startup. the effort is well Just remember that:
) PowerAll incur costs in excess of 50% that will jump-start.
B) PowerAll direct connection to the battery terminals. Do not try to extend the cable length, with a regular set of jumper cables.
C) remove within 10 seconds of starting the car.
2 After a jump-start a car battery, PowerAll of security features sometimes takes action, it was not until the setup. I suggest that after you jump start any disconnected PowerAll then press a button to see if the cost of the indicators light up blue. (Or if the flashlight is turned on) If not, simply plug into an AC outlet, household, or use an adapter (the property) PowerAll to pass the bill yourself a routine inspection of the setting itself. become active as soon as the blue lights start moving expenses. If you have enough money, you can unplug it and use it again immediately. If you have an adapter for your car, you can do this with a car that you just jump start! Just make sure it is working :).
3 protective cover (rubber flap) for connecting the cable to start may be very difficult to turn when fully closed. You must have some sharp object to pry it open from the end of the curve. Just be careful not to damage the inside. I recommend cutting a little off the end of the rubber flap so that you can more easily cover it with a finger nail or car keys. Be sure not to cut the rubber protrusions on the inside because they are designed to slide into the connectors for a secure fit.
4 Light LED - you have to hold the power button for 1-2 seconds to cycle through the flashlight mode LED (the flash SOS ticket) manual states that you have to press and hold the button to turn it on, then press it to change my mode PowerAll. To hold button for light mode.
5 Read the owner's manual, it will be very short (and small), but I will explain how to properly use the jump start. I still do backups because manufacturers do not appear to have the PDF.
Keep in mind that PowerAll designed to 12V and the device does not change the battery of your car. This unit aims to provide charging power to the battery in the car or your device. This is why it might not swing a dead battery as soon as you connect it PowerAll need a little time to push the battery, do not worry it does not take long at all!
Recommendations in Manufacturing
If I have only one suggestion for the design of PowerAll it will change the way LED * Power button * Hold button should also turn off the LED light and cycle through the modes. But the power off button should be pressed quickly. It is very difficult to ride a bike through the flashing LED mode just to turn off the lights in a dark room or tent, others do not appreciate the blinking light in their eyes. I have many complaints when I forgot to cover the light before turning it off.
PowerAll PBJS12000R Rosso Red/Black Portable Power Bank and Car Jump Starter
